Copyright WWW.DBBP.COM | updated 2-November-2020



 
 

The pointcover, printed in a mix of stainless and bronze, arrived. We polished the high spots and left the deeper bits dark and rough, came out pretty nice. Unfortunately the accuracy of this process is only 5 % so in this case this meant that the mounting holes came out too close together but we can fix that.


 
 

We used the welding table and some string to put the two wheels exactly in line and then started centering the rear fender to get the gaps between fender and wheel exactly even.


 
 

The sissybar had to be bent slightly and the front mount of the rear fender was cut loose and re-attached to get everything just right, much better now! Check out Aad testing the welder, haha




 
 

Previous