Copyright WWW.DBBP.COM | updated 11 March-2008

My BMW Bobber, part 78
CAD version here

Special thanks to:

 
 
 

Built a set of stainless steel handlebars out of 7 pieces of existing bars, welded in pieces of smaller diameter tube where the cables will exit. Cleaned up the regulator to prepare it for paint, heard a strange rattle inside, opened it up and it was full of rust....
Opened up a second regulator that looked like crap on the outside and the insides were like new, go figure! Aad machined a new driveshaft out of Chrome-Moly, 6 inches longer than stock! Tons of small details to do before Mainz....


 
 
 

Previous